There are many resources available to explain the LASIK procedure; however, very few detail the testing necessary leading up to the procedure. These tests can be seemingly overwhelming and technical. Some of the testing could have been done at an initial consultation, though, some tests may need to be repeated. Each test has a specific purpose to assist the surgeon in obtaining the best results possible.
The first step is to determine the uncorrected visual acuity, which is vision without glasses or corrective lenses. This raises the question of ?What does 20/20 mean?? In the U.S. vision is recorded on a chart with standardized letters calibrated to be read at 20 feet away. The fraction that describes vision, for instance, 20/20, 20/40, compares the smallest letters that a person with perfect vision can see at 20 feet to your vision at 20 feet. If you are only capable of seeing larger letters on the chart that can be seen by a normal person standing back 40 feet from it, then your vision is 20/40. 20/400, means at twenty feet from the chart you can only distinguish the giant E on top, which could be seen by a normal person from 400 feet away.
Some visual acuity levels bear special legal significance. For example, you must be able to see the 20/40 line of letters, or smaller, in order to drive without glasses in the U.S. For this reason, statistics for laser vision correction are often quoted in relation to the percent of patients receiving 20/40 vision or better. If the best vision a person can see with corrective lenses is 20/200 in both eyes, that person is legally blind.
Next, best-corrected visual acuity must be determined. Refractive error or acuity is measured one eye at a time, covering the other eye with an occluder. Refractive error is the state of the eye for which a prescription is normally given for glasses or contacts. Generally two refractions are completed on a person considering LASIK surgery. The first refraction is called a manifest refraction. A determination of th! e refrac tive error is the ?dry? or undilated state. The second is a cycloplegic refraction. This is similar to a manifest refraction except it is completed while your eyes are dilated. The reason for the cycloplegic refraction is to insure that the manifest is correct. When your eyes are dilated, you are unable to accommodate (focus up close) during the test.
Once your visual acuity has been determined, the results will be compared to your previous prescription to assure stability in refractive error. There should not be more than a half a diopter change in the past two years.
The next eye examination is performed with an instrument known as a slit lamp microscope that allows a binocular, high magnification view of the eye. This examination is used to rule out the presence of disease.
Keratometry is used to measure corneal curvature and is completed with a keratometer. This measures the shape of your cornea. Many surgeons have sophisticated topography equipment that obtains these measurements.
An Opthalmoscope is used to examine the back of the eye or ?retina? to exclude any tears, detachment or predisposing conditions. The optic nerve that carries vision from the retina to the brain is also observed for signs of glaucoma.
Corneal Topography is used to demonstrate astigmatism and other abnormalities such as keratoconus. Topography is a map of the eye showing the hills and valleys in color. Today?s more progressive equipment also measures pachymetry and keratometry during the course of the test.
Pachymetry is a measurement of the thickness of the center of the cornea. An ultrasound probe touching the surface of the cornea after an eye drop is administered for anesthesia constitutes Pachymetry. The thickness of the cornea is essential to determine the amount of correction that can be obtained. When LASIK is performed the laser ablates or removes some of the corneal tissue. The more correction that is needed, the more tissue is removed. This test along with the refraction is used! to make sure there will be enough tissue to maintain a stable healthy cornea.
Determination of the dominant eye is obtained for those patients who are either having one eye completed at a time or they have chosen to have monovision. If a person is having one eye completed at a time, most surgeons begin with the dominant eye.
The final test is the measurement of pupil size. This is important for those people who have very large pupils in dim light. This information can assist the surgeon in determining the size of the ablation area to avoid an extreme amount of glare and starburst post surgically in night driving.
All of these tests are necessary to have the most accurate results possible with LASIK surgery; nevertheless, it is always best to consult with an ophthalmologist with regards to specific circumstances.
By Shawn Powell
Shawn Powell is the Director of Marketing and Advertising for the Howerton Eye & Laser Center. Ernest E. Howerton, M.D. has been serving the Austin community for over 20 years. Having the procedure performed on him, Dr. Howerton understands the importance of the surgeon seeing the patient at every visit. He believes this practice is paramount to patient care and recovery. The Howerton Eye & Laser Center performs LASIK on site, with state-of-the-art equipment and an affordable, all-inclusive fee structure.
ไม่มีความคิดเห็น:
แสดงความคิดเห็น